The Design and Simulation Processing of Reading Lamp Mold

This subject design is to design the reading lamp mold and make the simulation processing of the mold cavity. In the design process, Pro/E Wildfire 4.0 were used to construct on the three dimensional modeling, make parting surface and make analys on mold flows, CAD were used to make parts drawing and assembly drawing, Master cam 9.1 were used to carry on the mold cavity simulation processing.  This mold according as the injection molding machine model and the efficient deterministic cavity which assigns based on the factory is two cavities  Considered many factors such as appearance requirements, a selection divided profile is modeling a bottom surface; In order to cause to model to be able the fast uniform cooling, cools the flow channel arrangement for to surround the type; Uses a balance -like divided flow channel, the side runner, at the same time the causing cavity obtains even fills and takes shape; prop up the organization is the product taking off patterns installment, go on the basis models a structure to use 8 mandril  Because models are the thin-wall construction possibly appears casts not completely, get across flows the analysis confirmation the mold to cast the fluid to be possible the filling cavity, conforms to the design requirement. The analysis cavity processing technics, completes the cutting tool way hypothesis in Master cam 9.1, the definite numerical control processing code, through the simulation processing determined whether satisfies the processing request.      Through the use mold design application software, makes the mold rated  capacity to enhance greatly, conforms to the design requirement completely.